What is the reason for the high vibration of the high-pressure blower

What is the reason for the high vibration of the high-pressure blower

During the actual operation of the high-pressure blower, this symptom may occur,

In fact, these symptoms can be divided into many different types. During exercise, you will find that after the equipment and motor vibrate,

The frequency or speed of vibration is the same, mainly due to the phenomenon caused by the imbalance of rotor mass,

In such a process, each rotational operation may also be impacted by centrifugal force caused by imbalance, so such vibration itself is the result of rational impact. So why does this situation occur?

1、 If the rotor has not undergone balance calibration, or if it has already undergone relevant calibration,

But when there is any looseness or displacement in the counterweight, it is necessary to conduct a balance check on all the adjusted positions. If they are not checked, they must be recalibrated.

2、 There is relatively more dirt attached to the surface of the rotor of the high-pressure blower. If there is dust or rust, it may disrupt the mass balance of these coils. In this case, it is necessary to clean the surface of the rotor.

3、 If installed incorrectly on the entire axial sealing device, it can cause localized friction in the entire axis or sealing ring,

It can cause overheating in the entire area and may also cause bending in the entire axial direction. If this happens, it is necessary to check the upper and lower clearances of the entire sealing ring and pay attention to straightening the bent axial direction.

4、 If there is a load change in the pipeline of the fish pond aerator, be sure to check the valve.